|
[Sponsors] |
November 27, 2007, 18:20 |
Mesh Deformation issues
|
#1 |
Guest
Posts: n/a
|
I am running a simulation using mesh deformation governed by fortran routines. To use the mesh deformation routines i have to run the solution in a transient mode. I only wish to perform the mesh deformation and user fortran routines at the 'start of run' however the routines are called at every time step. Is there any way of changing this?
..please say yes!! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
Mesh deformation, negative volume! | Turbomachine | CFX | 12 | June 9, 2011 08:05 |
CFX mesh deformation of fine elements | Ji Ke | CFX | 2 | January 30, 2008 03:38 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |