 |
 |
 |
|
|
|
[Sponsors] | ||||
December 18, 2007, 05:10
|
Solver stops abruptly without errors
|
#1 |
|
Guest
Posts: n/a
|
CFX 11.0 on Linux 8 node cluster. The solver stops abruptly after some thousand iterations without completion. No error message is shown. Solver status says it is running but the solver will not be running. If anybody has faced this problem , please help
|
|
|
||
|
December 20, 2007, 02:35
|
Re: Solver stops abruptly without errors
|
#2 |
|
Guest
Posts: n/a
|
We have been running CFX on Linux cluster. But, never faced any problem like this. May be because we did not run any problem on that cluster beyond 1000 iterations.
Speaking to CFX support team may help over here. Chirag |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 14:21 |
| Quarter Burner mesh with periosic condition | SamCanuck | FLUENT | 2 | August 31, 2011 12:34 |
| Getting too many iterations by velocity solving (aborting). Changing U - Solver? | suitup | OpenFOAM Running, Solving & CFD | 0 | January 20, 2010 08:45 |
| Setting a B.C using UserFortran in 4.3 | tokai | CFX | 10 | July 17, 2001 17:25 |
| Error during Solver | cfd guy | CFX | 4 | May 8, 2001 07:04 |
Linear Mode
