Home > Forums > Software User Forums > ANSYS > CFX

hi how to set entironment variable in CFX pre

Mark Forums Read

Reply

Search this Thread

December 23, 2007, 08:11	hi how to set entironment variable in CFX pre	#1
romance Guest Posts: n/a	(Transient Mesh Adaption Setup for CFX-5.7 Pre The following notes explain how to setup and run a transient mesh adaption case in CFX-5.7 using a specially patched version of CFX-Pre. The patch contains 5 files that should be copied into the appropriate places in the CFX installation, and is activated by setting the environment variable CFX5_TRANSIENT_ADAPTION=1. If this variable is not set, then Pre will behave exactly as the release version and you will be prevented from using the Adaption form with transient cases.) when i want to set environment variable , would you tell me how to realize ?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Instalation on ubuntu 710	basilwatson	OpenFOAM Installation	17	March 16, 2012 21:16
How to set boundaries about airfoil in CFX	adam_annie	CFX	2	January 24, 2010 20:20
Problem installing on 64bit with ver13	jonititan	OpenFOAM Installation	5	May 12, 2006 19:42
Problems with installation	jonititan	OpenFOAM Installation	4	November 6, 2005 05:16
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 21:09

All times are GMT -4. The time now is 22:29.