 |
 |
 |
|
|
|
[Sponsors] | ||||
January 20, 2008, 21:54
|
how many cycle should i put for iteration?
|
#1 |
|
Guest
Posts: n/a
|
Hi All,
Anybody here can give some advice on iterations cycle? How to define that the numbers that i put for iteration is stabile? thank you |
|
|
||
|
January 21, 2008, 05:32
|
Re: how many cycle should i put for iteration?
|
#2 |
|
Guest
Posts: n/a
|
You can use default number (100) for steady-state. If you don't get convergence after 150-200 iterations you should decrease a timescale or/and improve your mesh. Good luck!
|
|
|
|
||
|
January 22, 2008, 12:57
|
Re: how many cycle should i put for iteration?
|
#3 |
|
Guest
Posts: n/a
|
Or increase your timescale. It depends on what is holding it up.
|
|
|
|
||
|
January 24, 2008, 02:19
|
Re: how many cycle should i put for iteration?
|
#4 |
|
Guest
Posts: n/a
|
thank you guys
|
|
|
|
||
|
January 26, 2008, 08:57
|
Re: how many cycle should i put for iteration?
|
#5 |
|
Guest
Posts: n/a
|
I think 10 is a good number! I used to put 20 for transient analysis!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| THERMODYNAMIC CYCLE ANALYSIS SOFTWARE | P.PETER | Main CFD Forum | 7 | May 19, 2016 22:18 |
| [snappyHexMesh] How can I put snappy layers in a separate cellzone? | overkligheten | OpenFOAM Meshing & Mesh Conversion | 1 | April 5, 2010 09:18 |
| how to put post-processing values in a text file | herve | Siemens | 3 | March 31, 2008 10:07 |
| Multi cycle analysis | james | Siemens | 0 | April 11, 2005 13:03 |
| problem:case331,two stroke loop scavenge cycle 3D | lee ho boon | Phoenics | 1 | April 24, 2002 11:14 |
Linear Mode
