can use other shape of mesh instead of triangle?

January 24, 2008, 02:32

Hi,

Im using CFX mesh to do meshing. How can i set streight line meshing instead of triangle?

January 24, 2008, 04:34

There are only tetrahedrons and inflation triangle prisms (for a boundary layer) in CFX-Mesh . You can try to use other methods of WB Mesher (e.g. hexdominant). But for regular structured hexa mesh you should apply ICEM CFD.

January 24, 2008, 16:31

Hi,

Gen's answer is not complete. CFX supports tets (4 nodes), pyramids (5 nodes), prisms (6 nodes) and hexas (8 nodes). No other element type is supported.

Glenn Horrocks

January 24, 2008, 23:27

You can also create hexehedral meshes in Workbench Meshing by using the sweep method. This is most likely what you are looking for.

-CycLone

January 29, 2008, 02:25

Thank you Cyclone,

Can you give me more information on sweep mathod? Appriciate your advice.

warmest regards, Wan

January 24, 2008, 02:32	can use other shape of mesh instead of triangle?	#1
wan Guest Posts: n/a	Hi, Im using CFX mesh to do meshing. How can i set streight line meshing instead of triangle?

January 24, 2008, 04:34	Re: can use other shape of mesh instead of triangl	#2
Gen Guest Posts: n/a	There are only tetrahedrons and inflation triangle prisms (for a boundary layer) in CFX-Mesh . You can try to use other methods of WB Mesher (e.g. hexdominant). But for regular structured hexa mesh you should apply ICEM CFD.

January 24, 2008, 16:31	Re: can use other shape of mesh instead of triangl	#3
Glenn Horrocks Guest Posts: n/a	Hi, Gen's answer is not complete. CFX supports tets (4 nodes), pyramids (5 nodes), prisms (6 nodes) and hexas (8 nodes). No other element type is supported. Glenn Horrocks

January 24, 2008, 23:27	Re: can use other shape of mesh instead of triangl	#4
CycLone Guest Posts: n/a	You can also create hexehedral meshes in Workbench Meshing by using the sweep method. This is most likely what you are looking for. -CycLone

January 29, 2008, 02:25	Re: can use other shape of mesh instead of triangl	#5
Wan Guest Posts: n/a	Thank you Cyclone, Can you give me more information on sweep mathod? Appriciate your advice. warmest regards, Wan

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Number of cells in mesh don't match with size of cellLevel	colinB	OpenFOAM Meshing & Mesh Conversion	14	December 12, 2018 08:07
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
[Other] Dynamic Mesh Changing Shape	dancfd	OpenFOAM Meshing & Mesh Conversion	1	June 13, 2010 22:09
basic of mesh refinement	arya	CFX	4	June 19, 2007 12:21
Mesh	Mignard	FLUENT	2	March 22, 2000 05:12