|
[Sponsors] |
January 25, 2008, 07:28 |
Animation with CGNS file in tecplot
|
#1 |
Guest
Posts: n/a
|
Can anybody tell me how will I get "time" under "Animate" tab in tecplot 360?
I am only getting "Zones" under the " Animate" tab after loading the CGNS file. |
|
January 25, 2008, 11:20 |
Re: Animation with CGNS file in tecplot
|
#2 |
Guest
Posts: n/a
|
Normally CFX writes a single time step per CGNS file. So, if you have not already exported all your "trn" files, you will have to do it first. Then, you will have to combine all of them in a single file, but the easiest way is to use a Tecplot add-in for importing multiple transient files, which you can find at the Tecplot on-line community. Then, you will have to associate the zones to time steps, with another add-in, which is the "strand editor", found at the same place. You must have a recent Tecplot update installed. Good luck!
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 14:43 |
DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 02:24 |
Multiblock animation in Tecplot. | Simon | Tecplot | 4 | February 10, 2006 11:27 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 16:16 |
Animation in Tecplot | ryoga | Tecplot | 0 | February 18, 2002 12:19 |