Home > Forums > Software User Forums > ANSYS > CFX

Meshing from Command Line

Mark Forums Read

Reply

Search this Thread

January 29, 2008, 19:01	Meshing from Command Line	#1
Yakn Guest Posts: n/a	Hi, Just wondering if there is a way to set meshing parameters in ICEM and then run the actual meshing process through the command line... Thanks, Yakn

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 05:22
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 11:03
Meshing locks workbench window.	andy2o	CFX	0	February 1, 2008 05:01
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 11:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 11:08

All times are GMT -4. The time now is 04:33.