|
[Sponsors] |
January 31, 2008, 06:55 |
Error: non-reflecting boundary conditions
|
#1 |
Guest
Posts: n/a
|
when simulate gravity wave, i enable outlet NRBC and it gives the following error: help highly appreciated !
Details of error:- ---------------- Error detected by routine PEEKR CDANAM = VARIABLES/NRBC/NRBC_WAVE/VALUE CRESLT = NONE Current Directory : /FLOW/BOUNDCON/ZN1/BCP3 +--------------------------------------------------------------------+ | ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | Stopped in routine MEMERR |
|
January 31, 2008, 17:28 |
Re: Error: non-reflecting boundary conditions
|
#2 |
Guest
Posts: n/a
|
Hi,
I think the non-reflecting boundary condition is a beta feature so bugs like this should be reported to the developers. I would report it to your CFX rep. Glenn Horrocks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 14:06 |
Domain Imbalance | HMR | CFX | 5 | October 10, 2016 06:57 |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 13:58 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 7, 2008 00:17 |
A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 19:29 |