Meshing locks workbench window.
 

Hi All,

I'm using CFX 11 SP1. When I start meshing in a Workbench session, Workbench is then 'locked' onto the meshing pane until the meshing is complete ~20 min later.

* Is there any way I can access DesignModeler and continue my work there whilst meshing is in progress?

* Is this 'locking up' a consequence of having only one set of licenses, or does it always happen?

Many thanks for your suggestions, Andy.

(I'm building a rather detailed geometry in stages, and meshing it regularly to catch problems and run test calculations, so this isssue is causing me a lot of wasted time. I'm reluctant to leave all my meshing until the end because I have uncovered a lot of small errors by meshing regularly)