CFD Online Logo CFD Online URL
Home > Forums > CFX

Surface roughness

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   February 8, 2008, 12:25
Default Surface roughness
Posts: n/a

can we have surface roughness and Yplus cell height which is less than the surface roughness cell height for a No slip wall in CFX,is there any best practices.

thanks in advance
  Reply With Quote

Old   February 10, 2008, 17:36
Default Re: Surface roughness
Glenn Horrocks
Posts: n/a

Numerically it should cause no problems and run fine. Whether it has any physical significance - that is whether it is accurate or not is a matter of debate and probably depends on exactly what you are modelling.

Glenn Horrocks
  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
nutRoughWallFunction and Surface Roughness Documented AlanR OpenFOAM Programming & Development 55 October 24, 2016 11:10
Error : Self intersecting surface mesh, computing intersections & Error : Impossible velan Open Source Meshers: Gmsh, Netgen, CGNS, ... 3 October 22, 2015 11:05
Problem with Gmsh nishant_hull Open Source Meshers: Gmsh, Netgen, CGNS, ... 23 August 5, 2015 02:09
Surface roughness alefem FLOW-3D 6 June 3, 2010 12:49
CFX4.3 -build analysis form Chie Min CFX 5 July 12, 2001 23:19

All times are GMT -4. The time now is 12:15.