Home > Forums > Software User Forums > ANSYS > CFX

Initialisation problem Turbo tool CFX-Post

Mark Forums Read

Reply

Search this Thread

February 13, 2008, 05:44	Initialisation problem Turbo tool CFX-Post	#1
Toralf Guest Posts: n/a	Hi, I consider a simple 1-stage (stator, rotor) turbo problem. After a converged calculation I cannot run the initialisation tool in CFX-Post. It appears the Message "Warning Failed to initialize component 'XYZ' domain for conversion type 'Cartesian to turbo' I have definde each Hub, Shroud, Blade etc. Please have anybody suggestions for this problem? Thank you very much. Regards, Toralf

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFX Post export problem	jeff_F	CFX	0	August 17, 2009 21:25
CFX 11, post	Anant	CFX	1	June 24, 2008 11:03
CFX 5.5.1 stirred tank and LES problem	Nishant	CFX	2	September 13, 2002 07:11
creating expresions in cfx build or cfx post	alex	CFX	1	August 22, 2002 13:01
CFX 4.4 installation problem	Pandu Sattvika	CFX	1	December 1, 2001 04:07

All times are GMT -4. The time now is 13:53.