optimizating flow (staticmixer tutorial)

February 20, 2008, 22:58

Hi,

I am following the static mixer tutorial and when I load up the design explorer the only parameter's i can modify are the velocity inlets. I want to be able to modify the geometry. I did check the bock in design modeler to indicated a parameter. Is there something I missed?

February 20, 2008, 23:57

I've had this same problem, but with a structral simulation, so I hope this works!

Try this :

When in the project tab of Workbench

-Select the geometry once -look to the left under "Default Geometry Options" and delete the "DS" in the Parameters box.

This should publish the parameter for use in DesignXplorer.

February 20, 2008, 22:58	optimizating flow (staticmixer tutorial)	#1
mike Guest Posts: n/a	Hi, I am following the static mixer tutorial and when I load up the design explorer the only parameter's i can modify are the velocity inlets. I want to be able to modify the geometry. I did check the bock in design modeler to indicated a parameter. Is there something I missed?

February 20, 2008, 23:57	Re: optimizating flow (staticmixer tutorial)	#2
Dre Guest Posts: n/a	I've had this same problem, but with a structral simulation, so I hope this works! Try this : When in the project tab of Workbench -Select the geometry once -look to the left under "Default Geometry Options" and delete the "DS" in the Parameters box. This should publish the parameter for use in DesignXplorer.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
flow over a cylinder urgent!	kevin	FLUENT	8	August 11, 2015 13:00
Fluent tutorial for turbulent flow	Jenner	FLUENT	8	December 12, 2006 03:26
potential flow vs. Euler flow	curious ...	Main CFD Forum	23	July 21, 2006 07:40
transform navier-stokes eq. to euler-eq.	pxyz	Main CFD Forum	37	July 7, 2006 08:42