|
[Sponsors] |
March 7, 2008, 12:17 |
meshes interface ?
|
#1 |
Guest
Posts: n/a
|
Hi,
i want to know if we have 2 meshes ,should the interface (shared surface have the same mesh ,i.e;mesh size )? thanks |
|
March 7, 2008, 13:42 |
Re: meshes interface ?
|
#2 |
Guest
Posts: n/a
|
It's probably a good idea to have the same mesh 'size' at an interface to make the problem solution transition better at the interface. It's not absolutely necessary though. You also don't have to have the same type of mesh on either side of the interface. I regularly interface tets with hexes but try and keep the same general size of cell.
Rod |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Interface between meshes and high skewness | Danny | FLUENT | 0 | September 13, 2005 11:23 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |