|
[Sponsors] |
March 7, 2008, 18:13 |
Question on blade meshing
|
#1 |
Guest
Posts: n/a
|
Hi guys,
I'm trying to do a simulation on a micro jet engine without any combustion model at the moment, just airflow. I have a question regarding blade meshing. I'm aware that one can easily generate a blade mesh using BladeGen and TurboGrid for one single blade. My question is, Is there any way that I can generate a blade mesh for more than 1 blade? I need 3 blades in one mesh. Currently, I'm just importing the 1-blade mesh and transform(rotate) it to create 2 other in CFX-pre for my simulation. Any help would be very much appreciated. Regards, Jeff |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Meshing very thin blade tip | Jenny | CFX | 7 | June 27, 2014 09:26 |
Meshing problem trailing edge of blade | ben-18 | ANSYS Meshing & Geometry | 1 | July 13, 2011 11:39 |
Rotating blade in circular/square vessel (Salome+OpenFoam) | voingiappone | OpenFOAM | 0 | May 19, 2011 12:38 |
Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 06:01 |
gambit meshing scheme question | Juliana P | FLUENT | 1 | October 28, 2005 10:15 |