Home > Forums > Software User Forums > ANSYS > CFX

flow over an infinite flat plate

Mark Forums Read

Reply

Search this Thread

April 7, 2008, 05:01	flow over an infinite flat plate	#1
Vijay Guest Posts: n/a	Dear friends, I am trying to simulate "flow over an infinite flat plate". I am taking a plate of unit width. I think I have to use "interface domain" BC to solve this. It asks to specify 2 regions in that. I have (a)inlet (b)outlet (c)symmetry & (d)wall-no slip boundary conditions. (c) & (d) are in between (a) & (b). Questions: Which regions I have to specify for "interface domain" as region-1 & region-2 ? At the same time, I have some known velocity at the inlet. Plz reply. Thank you..

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Boundary Layer of Laminar Flow over a Flat Plate	Blasius_Pohlhausen_Crocco	Main CFD Forum	12	September 30, 2013 17:35
entrance of a flat plate	mc	Main CFD Forum	0	April 24, 2007 22:38
supersonic flow over a flat plate	Vishwajeet	Main CFD Forum	1	April 15, 2007 22:00
results for flow past flat plate normal to flow	lisa	Main CFD Forum	2	August 30, 2005 16:36
Question on 3D potential flow	Adrin Gharakhani	Main CFD Forum	13	June 21, 1999 05:18

All times are GMT -4. The time now is 21:24.