|
[Sponsors] |
April 14, 2008, 01:36 |
Kimora mesh
|
#1 |
Guest
Posts: n/a
|
Could anyone explain me 1)what is the use of kimora meshing technique? 2)Which tool(Like ICEM) handle this technique? 3)Where can i get the tutorials?
|
|
April 19, 2008, 10:37 |
Re: Kimora mesh
|
#2 |
Guest
Posts: n/a
|
Hello sudhakar,
I'm going guess that you're asking about the Chimera (overset) grid technique. Many mesh generation tools can create these types of meshes including ours (Gridgen and Pointwise). But the hard part isn't necessarily the mesh generation itself. Rather, computation of the overlap (hole cutting) can be rather interesting. Software like PEGASUS is used for this job. There's a bi-annual conference on overset methods and this year's event will be held in October. Here is the web site. http://www.outreach.psu.edu/programs/overset/ Hope this helps. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 07:41 |
Converting Starccm+ mesh | Ladnam | OpenFOAM | 0 | September 14, 2011 07:30 |
Meshing aifoil in ICEM | student123a | ANSYS Meshing & Geometry | 13 | December 8, 2010 11:40 |
2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 05:49 |
basic of mesh refinement | arya | CFX | 4 | June 19, 2007 13:21 |