turboGrid help.

April 21, 2008, 06:43

Hello,

1. I have cross-section data of a turbine blade at hub, mean and tip (in x,y,z coordinates). can I make full turbine blade out of this data in Ansys BladeModeler 11.0.

2. If a make a mesh in Ansys TurboGrid, can i export this mesh to Fluent for CFD analysis.

3. Are there any tutorials available for Ansys BladeModeler 11.0.

Many Thanks,

I would be very grateful for your kind help.

sivarama1 · February 13, 2016, 03:54

Here with i am attaching my results.could you please find correct variation.
In this regards to fine Turbulence condition.

April 21, 2008, 06:43	turboGrid help.	#1
Muhammad Usman Qureshi Guest Posts: n/a	Hello, 1. I have cross-section data of a turbine blade at hub, mean and tip (in x,y,z coordinates). can I make full turbine blade out of this data in Ansys BladeModeler 11.0. 2. If a make a mesh in Ansys TurboGrid, can i export this mesh to Fluent for CFD analysis. 3. Are there any tutorials available for Ansys BladeModeler 11.0. Many Thanks, I would be very grateful for your kind help.

February 13, 2016, 03:54	Turbulence condition	#2
sivarama1 Member sivaramakrishnaiah Join Date: Mar 2009 Location: india,pondicherry Posts: 76 Rep Power: 17	Here with i am attaching my results.could you please find correct variation. In this regards to fine Turbulence condition. __________________ sivaramakrihnaiah

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[TurboGrid] GE rotor B geometry for Ansys turbogrid	sonny	ANSYS Meshing & Geometry	6	August 29, 2014 20:01
Importing ICEM mesh in TurboGrid	ayothicfd	Main CFD Forum	0	October 8, 2011 10:23
[TGrid] Bladegen w/o turbogrid	Biskvito	ANSYS Meshing & Geometry	5	September 6, 2011 08:13
Axial blade simulation, TurboGrid a must?	Gentry	CFX	1	March 19, 2009 10:20
How to refine leading edge mesh in TurboGrid 10	Christian	CFX	7	May 30, 2006 14:24