How to run ICEM-CFD in paralle model?
Hi i want to make a grid for LES ,but it is need long time to make grid,as i know ICEM can run in paralle model,how could it run in paralle way such as PVM or MPICH?
wayne |
Re: How to run ICEM-CFD in paralle model?
ICEM Tetra runs in parallel on shared memory machines. (I'm not aware that it can run distributed.) Just set the number of processors in the settings menu.
|
Re: How to run ICEM-CFD in paralle model?
where?i can not find this setting?is the ICEM Tetra the different version of ICEM?
|
Re: How to run ICEM-CFD in paralle model?
You should find the "Number of processors"-option in the main menu as follows: Select "Settings", select "General" and type in the number of processors you can/want to use... hth, joerg.
|
Hello!
Do you able to run ICEM over parallel mode? I cannot do this by assign a number to Settings => General => number of processors. ICEM still use one processor! |
ICEM only does a few operations multiprocessor. You will need to do a big meshing job to see it.
|
All times are GMT -4. The time now is 19:03. |