|
[Sponsors] |
September 2, 2010, 04:26 |
boiling with timedependent variation
|
#1 |
New Member
Erkan
Join Date: May 2010
Posts: 9
Rep Power: 15 |
Dear cfx-users,
i am dealing with a transient boiling problem and i can not get expected results. Case is a channel (with water and steam as particle model from IAPS-TABLE) with a certain number of heaters (heat flux is not constant for them ). I am also using the RPI model. Boundary Conditions are about 60-90Mpa for Pressure and Temp: 280-300 Celsius and heaters are the power is in a region of MegaWatts. Fact is that the liquid is boiling! However: I used the boiling model with phase change (for almost all available water-steam tables), but during the calculation the vapour value (condensing/vaporisation) is not changing (e.g. by reducing or increasing heatflux, inputflow etc. etc.). What can be wrong? where could be a mistake? Did I forget sth.? I would be really glad about some hints and help. Thanks a lot to all Best wishes uwsa |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to model boiling process | wanghong | FLUENT | 2 | October 1, 2010 17:07 |
Boiling on Mountaintop | Frank | Main CFD Forum | 3 | January 16, 2009 16:33 |
VOF vs BOILING | greg | FLUENT | 0 | April 1, 2007 10:59 |
-What udf macro for boiling - | thomas | FLUENT | 6 | January 19, 2004 07:31 |
pool boiling curve | David Gibson | Main CFD Forum | 0 | November 10, 1998 23:06 |