ICEM: mesh export error

May 16, 2008, 11:23

hi dudes

I finished meshing my stuff and wanted to export the mesh to cfx. the error I get is: "mesh contains ORFN elements. interace exits due to invalid mesh"

duh ... somethings wrong with my mesh, but what?

I've let the mesh-check run over it, found a few problems and deleted them.

somebody an idea?

thx

May 16, 2008, 12:32

Hi! I have the same problem!!!

How can i resolve:

delaunay-violation?

penetrating elements?

surface orientations?

stuck elements?

and if i want save a mesh in the fluent_v6 format, i've always this error:

CHILD KILLED: SEGMENTATION VIOLATION

How cai i do?

Thanks'

Francesco

vmlxb6 · September 2, 2010, 07:51

I know this is too late but I am having the same problem. I created a 2-D mesh in ICEM and when I imported it CFX it gave the following error:

Child killed: segmentation error

Thanx and regards,

Lobo Varun M.

May 16, 2008, 11:23	ICEM: mesh export error	#1
icem-noob Guest Posts: n/a	hi dudes I finished meshing my stuff and wanted to export the mesh to cfx. the error I get is: "mesh contains ORFN elements. interace exits due to invalid mesh" duh ... somethings wrong with my mesh, but what? I've let the mesh-check run over it, found a few problems and deleted them. somebody an idea? thx

May 16, 2008, 12:32	Re: ICEM: mesh export error	#2
Francesco - University of Florence, Italy Guest Posts: n/a	Hi! I have the same problem!!! How can i resolve: delaunay-violation? penetrating elements? surface orientations? stuck elements? and if i want save a mesh in the fluent_v6 format, i've always this error: CHILD KILLED: SEGMENTATION VIOLATION How cai i do? Thanks' Francesco

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Building OpenFOAM1.7.0 from source	ata	OpenFOAM Installation	46	March 6, 2022 14:21
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 07:20
c++ libraries and solver compiling	vaina74	OpenFOAM Installation	13	February 3, 2012 18:43
ParaView for OF-1.6-ext	Chrisi1984	OpenFOAM Installation	0	December 31, 2010 07:42
checking the system setup and Qt version	vivek070176	OpenFOAM Installation	22	June 1, 2010 13:34

September 2, 2010, 07:51		#3
vmlxb6 Senior Member Ugly Kid Joe Join Date: Aug 2010 Posts: 193 Rep Power: 17	I know this is too late but I am having the same problem. I created a 2-D mesh in ICEM and when I imported it CFX it gave the following error: Child killed: segmentation error Thanx and regards, Lobo Varun M.