 |
 |
 |
|
|
|
[Sponsors] | ||||
Initial condition file from different Bndry condit |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 20, 2008, 17:28
|
Initial condition file from different Bndry condit
|
#1 |
|
Guest
Posts: n/a
|
Hi, I changed the specified mass flow at one of the two outlets of my domain. Now I want to run the simulation. I am wondering if I can use the result file obtained from the previous simulation (different mass flow at the outlet) as the initial condition file for this simulation. Please suggest, Kushagra
|
|
|
||
|
May 20, 2008, 21:49
|
Re: Initial condition file from different Bndry co
|
#2 |
|
Guest
Posts: n/a
|
yes you can use it!
|
|
|
|
||
|
May 20, 2008, 21:50
|
Re: Initial condition file from different Bndry co
|
#3 |
|
Guest
Posts: n/a
|
Thanks Rogerio
|
|
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Velocity blows up suddenly after 30,000+ iterations | lordvon | OpenFOAM Running, Solving & CFD | 15 | October 19, 2015 14:52 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 06:24 |
| Error while running rhoPisoFoam.. | nileshjrane | OpenFOAM Running, Solving & CFD | 8 | August 26, 2010 13:50 |
| ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 12:46 |
| IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 03:58 |
Linear Mode
