CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   Integer Memory - Problem (

Mehul May 22, 2008 23:24

Integer Memory - Problem

I am working on a project where I have to finalised the agitator profile and accesories. I have generated mesh with 4 lcs nodes with agitator as rotating domain and the rest of the tank as a stationary. Now my question is , when I start a simulation run, It crashes with the message that " You need to increase the integer memory". I am not getting what is wrong with set up or else. Can anyone help on this issue.

Aero75 May 23, 2008 01:50

Re: Integer Memory - Problem
Hi Mehul,

When you define your run in solver-manager there is an "show advanced controls" tick that you need to switch on. Then under the solver tab, you can make detailed memory overrides. You can e.g. increase the integer memory allocation by a factor of 1.2 by writing 1.2x in the appropriate field.

Regards Aero75

Mehul May 23, 2008 02:53

Re: Integer Memory - Problem
Thanks Aero,

Let me try this , I think it should work.

Regards Mehul

All times are GMT -4. The time now is 10:07.