CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   extrude 2D mesh (

stefan June 8, 2008 05:34

extrude 2D mesh
Hi everybody,

I would like to know if it is possible to make at once in 2D extrude mesh in cfx for 3 or more parts.In Advancing front and inflation 3D i can make more periodicity pairs, but when i swith the option to extrude 2D mesh, only one extrude pair is valid.Can you give me some usefull information please?


CycLone June 8, 2008 21:41

Re: extrude 2D mesh
Hi Stefan,

You can pick more than one surface for each side. Try including on face from all three parts in each side of your periodic pair.

Alternatively, you can use the sweep method, instead of the CFX-Mesh method, or you can assign a separate CFX-Mesh method to each part.


All times are GMT -4. The time now is 22:37.