|
[Sponsors] |
June 23, 2008, 01:17 |
ICEM geometry
|
#1 |
Guest
Posts: n/a
|
Hi,
Can anyone tell me where the "extrude", "thin/surface", and "revolve" options are located in ANSYS ICEM 11? I used these options in WORKBENCH but cannot find them in ICEM. Thanks, CC. |
|
June 23, 2008, 02:48 |
Re: ICEM geometry
|
#2 |
Guest
Posts: n/a
|
"extrude" is in "edit mesh" I do not know the last two options.
|
|
June 25, 2008, 01:18 |
Re: ICEM geometry
|
#3 |
Guest
Posts: n/a
|
icem does not have thin surface option as it is basically a mesh generator and not a CAD tool. you will find Revolve under "edit mesh" as well.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] blocking a seal geometry in ICEM HEXA | Chilli | ANSYS Meshing & Geometry | 1 | October 21, 2011 02:28 |
flow over an airfoil 3d ( Geometry on icem cfd ) | dfmona | Main CFD Forum | 0 | April 13, 2010 23:32 |
ICEM: Holes in Geometry | Daniel | CFX | 4 | February 22, 2009 09:40 |
2D geometry in ICEM | NITIN DEWANGAN | CFX | 3 | August 21, 2008 17:25 |
How to do Geometry from 3D mesh in ICEM | San24 | Main CFD Forum | 4 | August 8, 2005 02:49 |