Wall heat transfer coefficient -plot in post
Hi I had solved a problem in NaturalConvection ie of fully buoyanct model;there while plotting Wall heat transfer coefficient value when given For a particular heat sink region colour-range-local ..i would get a value range of about 3000Wm^2K^-1 as maximum value. but given colour-range -userspecified - (a range of about )0 to 30Wm^2K^-1 ,there was not even a mark of red (ie highest value plot is not even 30Wm^2K^-1... Could u suggest what values have to be taken as correct.
thanks |
All times are GMT -4. The time now is 11:58. |