|
[Sponsors] |
August 25, 2008, 07:01 |
MFX
|
#1 |
Guest
Posts: n/a
|
Hi everyone,
I am struggling with doing a 3D FSI simulation (bridge deck in airflow). I made an Ansys input file and a CFX model. It seems the simulation runs correctly, but zero forces sent by the CFX to the Ansys solver, and consequently no mesh deformation at all. There is an inlet velocity, so force should be appeared on the solid object... Thanks, Geri |
|
August 31, 2008, 16:34 |
Re: MFX
|
#2 |
Guest
Posts: n/a
|
Are you sure you selected the corrected face(s) for interfacing both in fluid and solid parts? I made that mistake once and it was because I selected the wrong face.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fluid Structure Interaction using MFX : ANSYS-CFX | Manoj Kumar | CFX | 2 | June 3, 2015 07:41 |
ANSYS/CFX, MFX, piezoelectric actuated micro-pump problem | gogohusky | CFX | 9 | November 15, 2014 02:37 |
FSI - verification force mapping with mfx | Vinzent | CFX | 15 | September 18, 2011 18:00 |
MFX mechanical input file | vovogoal | CFX | 0 | March 18, 2011 22:19 |
FSI with MFX | V. Kumar | CFX | 9 | July 21, 2009 04:22 |