CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   block strategy in ICEM (

Li October 15, 2008 04:51

block strategy in ICEM
Hi,I am generating mesh in ICEM. It's a room ventilation with several slots on the ceiling. After I blocked the model with 3D block, I only got the mesh on the whole surface including ceiling and inlet without recognizing the vertex of inlet at all. In this case, may I make another surface block except for the 3D block? Does it mean multi-block? I am going to use cfx to do the simulation. Thank you!

Li October 16, 2008 04:20

Re: block strategy in ICEM
I found the way using split face. Thanks.

All times are GMT -4. The time now is 23:47.