|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
hi everybody I tried to model a viscous flow by "pressure inlet" and "pressure outlet" in CFX 5. But there is a trouble and CFX announced "floating point exception" and suddenly solve is terminate with error. I can't solve my problem. I studied CFX manual. It offers that applicants should use "velocity inlet"! But my problem is that I have to use "pressure inlet". I applied inlet, outlet and opening boundary conditions together but solve failed too soon. What can I do? I would be very grateful for any advice.
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
I would try running with a different scheme or timestep. Often its the path the mathematics take to arrive at the converged solution which causes the problem. Trying a different scheme or timestep alters the path slightly, which sometimes avoids this.
Or you can try using double precision. Cheers Adam |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Hi and thank for your attention I studied your comment. I'll try to solve my problem in regard to your advice. I'll announce you results. Good luck.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
MPI Error - simpleFoam - Floating Point Exception | scott | OpenFOAM Running, Solving & CFD | 3 | April 13, 2012 16:34 |
Finished simulation doesn't start: floating point exception [Divide by zero] | MaxCFD | STAR-CCM+ | 3 | June 26, 2011 10:31 |
reactingFoam floating point exception | pajofego | OpenFOAM | 0 | November 6, 2010 17:29 |
Cannot Open .sim (Floating Point Exception) | trex930 | STAR-CCM+ | 1 | July 30, 2010 06:51 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |