 |
 |
 |
|
|
|
[Sponsors] | ||||
November 18, 2008, 07:52
|
Two phase flow with phase change
|
#1 |
|
Guest
Posts: n/a
|
Dear all,
I am simulating two phase flow (Liquid water and vapor) with phase change. I would like to generate superheated steam from sub-cooled liquid. I am using continuous continuous Euler Euler inhomogeneous model. I am facing convergence problems and the mass and energy imbalance are very large. Any help is welcome. Regards Ahmad |
|
|
||
|
November 26, 2008, 03:59
|
Re: Two phase flow with phase change
|
#2 |
|
Guest
Posts: n/a
|
For convergence , set the lower values in Expert parameter >> Convergence control >> Relaxation parameters 0.25 will give you very good mas convergence. -mohan
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multiphase flow and Phase change due to heat transferevaporation | haghajani | OpenFOAM Running, Solving & CFD | 88 | February 11, 2020 08:00 |
| gas-liquid 2 phase flow in microchannels using VoF | LyngHoo | FLUENT | 1 | November 13, 2012 19:01 |
| conjugate heat transfer with phase change | mogoko | CFX | 2 | March 23, 2011 11:25 |
| Validation for laminar Disperse phase flow | shashwat | Main CFD Forum | 0 | April 4, 2008 02:20 |
| Two-phase/ Single phase mix flow | Reza | Main CFD Forum | 1 | August 6, 2003 06:36 |
Linear Mode
