NACA 23020 airfoil drag and lift calculation.
Hello everyone! I'm trying to calculate lift and drag for NACA 23020 airfoil using ANSYS Workbench, but I can't get correct results. Is there some kind of a guideline for this? Thank you in advance.
|
Re: NACA 23020 airfoil drag and lift calculation.
Hi,
This question is asked so much we should write a FAQ on it... Any takers? The CFX documentation has a good guide for getting accurate results. That's definitely a good place to start. All these parameters need to be taken care of for a good result: * Simulation physics matching reality * Domain large enough to not affect results * Mesh quality acceptable * Mesh resolution OK * Converged * If transient, time step size is OK Glenn Horrocks |
Re: NACA 23020 airfoil drag and lift calculation.
Thanks. I'll look more thoroughly through the documentation.
|
All times are GMT -4. The time now is 21:41. |