|
[Sponsors] |
December 31, 2008, 07:14 |
Iteration Problem
|
#1 |
Guest
Posts: n/a
|
Hi all,
I am doing simulation using turbulence equation(BSL) in ansys cfx for straight microchannel.The iteration for momentum and mass are converged, but for the Turbulence(KO)especially for RMS K-TurKE it show 0-value after 100times of iterations. Im not sure whether it is converged or not. and how to verify it.Could anyone advice?Thanks for your time. Simon. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to increase "Newton Pressure Iteration Limit" | kus | CFX | 9 | April 21, 2013 02:54 |
a problem of nozzle simulation | xck1986 | OpenFOAM | 11 | November 27, 2012 09:22 |
Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 06:29 |
The problem of inner iteration when calling the subroutine | guoxj | CFX | 18 | October 23, 2010 21:37 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |