 |
 |
 |
|
|
|
[Sponsors] | ||||
January 21, 2009, 13:48
|
what is ACA on Meridional surface?
|
#1 |
|
Guest
Posts: n/a
|
for example, pressure ACA on Meridional surface. I am running a compressor simulation. What does ACA stand for?
Thanks! |
|
|
||
|
January 25, 2009, 07:47
|
Re: what is ACA on Meridional surface?
|
#2 |
|
Guest
Posts: n/a
|
Area Circuferential Average
CFX makes a new variable whenever you calcuate an average value on a meridional surface, and it prefixes the variable with LCA, ACA, or MCA based on what type of circ. averaging was performed (Length, Area, Mass). |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 12:12 |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 12:05 |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 03:09 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 13:43 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
