Cannot see residuals while solving

January 26, 2009, 22:28

Ok so I did a clean install of vista 64 and now I have a weird problem. When I run the simulation, I can see the text information on the right but where the residuals are supposed to be, it's just gray. When I try to create a new monitor, I can't select any variables. However, when I stop the simulation, sometimes the residual graphics appears.

I have tried uninstalling CFX and reinstalling, but the problem persists. I haven`t tried a complete reinstallation of ANSYS yet. Could this be just some sort of problem with options setting?

Any solution proposition are welcomed!

January 27, 2009, 16:23

Hi,

Sounds like a graphics card issue. Have you checked your graphics card driver is up to date?

Glenn Horrocks

January 27, 2009, 20:27

Yes my drivers are up to date.

It could be a graphic problem, but I can't add a monitor either, so that's probably not it.

January 29, 2009, 11:00

Ok so if I create a new simulation, everything works fine.

But when I try to run previous simulations, I run in the same problem.

January 26, 2009, 22:28	Cannot see residuals while solving	#1
Dre Guest Posts: n/a	Ok so I did a clean install of vista 64 and now I have a weird problem. When I run the simulation, I can see the text information on the right but where the residuals are supposed to be, it's just gray. When I try to create a new monitor, I can't select any variables. However, when I stop the simulation, sometimes the residual graphics appears. I have tried uninstalling CFX and reinstalling, but the problem persists. I haven`t tried a complete reinstallation of ANSYS yet. Could this be just some sort of problem with options setting? Any solution proposition are welcomed!

January 27, 2009, 16:23	Re: Cannot see residuals while solving	#2
Glenn Horrocks Guest Posts: n/a	Hi, Sounds like a graphics card issue. Have you checked your graphics card driver is up to date? Glenn Horrocks

January 27, 2009, 20:27	Re: Cannot see residuals while solving	#3
Dre Guest Posts: n/a	Yes my drivers are up to date. It could be a graphic problem, but I can't add a monitor either, so that's probably not it.

January 29, 2009, 11:00	Re: Cannot see residuals while solving	#4
Dre Guest Posts: n/a	Ok so if I create a new simulation, everything works fine. But when I try to run previous simulations, I run in the same problem.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Extrusion with OpenFoam problem No. Iterations 0	Lord Kelvin	OpenFOAM Running, Solving & CFD	8	March 28, 2016 11:08
Orifice Plate with a fully developed flow - Problems with convergence	jonmec	OpenFOAM Running, Solving & CFD	3	July 28, 2011 05:24
Differences between serial and parallel runs	carsten	OpenFOAM Bugs	11	September 12, 2008 11:16
IcoFoam parallel woes	msrinath80	OpenFOAM Running, Solving & CFD	9	July 22, 2007 02:58
Could anybody help me see this error and give help	liugx212	OpenFOAM Running, Solving & CFD	3	January 4, 2006 18:07