|
[Sponsors] |
February 12, 2009, 00:13 |
Expression for Monitor point
|
#1 |
Guest
Posts: n/a
|
Hi! I am doing simulation of axial flow Pump. During post analysis in cfx, I found that abbsolute pressure on the suction side is to much low in some area around the blade tip so it should create the problem of cavitation. Now i want how much volume or area around blade has pressure below some value say 85 kpa,this can be found in post through isovolume but how can I put in the form of expression i cfx pre to monitor it in cfx-solver. Thanks
|
|
February 12, 2009, 16:12 |
Re: Expression for Monitor point
|
#2 |
Guest
Posts: n/a
|
Hi,
You should be able to construct this using an additional variable. You could set an additional variable to be 1 if <85kPa and 0 if >85kPa then you calculate the volume integral of the additional variable and it will give you the volume <85kPa. Glenn Horrocks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem About Running Fluent In Linux | mitra | FLUENT | 18 | June 20, 2019 02:11 |
How to install CGNS under windows xp? | lzgwhy | Main CFD Forum | 1 | January 11, 2011 18:44 |
CGNS lib and Fortran compiler | manaliac | Main CFD Forum | 2 | November 29, 2010 06:25 |
Lift, Drag Vs time chart,calculations | Jamesd69climber | CFX | 8 | February 17, 2005 17:23 |
Creating, loop or iteration using expression edito | Jan | CFX | 3 | July 28, 2003 11:01 |