|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Dr. Flow Squad
Join Date: Mar 2009
Posts: 17
Rep Power: 18 ![]() |
I would like to work on a case including boiling of water. I have looked at the test example of boiling of water in the installation directory and it works fine for me and I understand it fully. It consist of "Water at 100C" and "Water Vapour at 100C".
Now I want to add a 3rd phase which is pure "air ideal gas". In my specific case I use the hot air to heat up water until it boils. The water enters a duct with hot air which make some of the water boil and form vapor. But I cannot setup my case since I have 2 continuous phases. Is there a correct way to set up my case? please advice br Dr. Flow Squad |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
peterlee
Join Date: May 2009
Posts: 10
Rep Power: 17 ![]() |
Hi, does the boiling model in the installed directory really fill you?
I am searching for a well boiling model, but there are some problems! ![]() one case, the water tempreture reaches 590k, and there have no water vapour!!! ![]() another case, without heating, the water was boiling, and the curves are wrong!!! ![]() So, I urgently need your help! |
|
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
Dr. Flow Squad
Join Date: Mar 2009
Posts: 17
Rep Power: 18 ![]() |
Sorry. Not much have happened since.
|
|
![]() |
![]() |
![]() |
Tags |
air, boiling, evaporation, vapor, water |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
water spray in hot air | krish | FLUENT | 6 | April 3, 2013 08:58 |
air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 07:59 |
Water jet in confined hot air cross flow | Jim Clancy | FLUENT | 0 | November 24, 2007 16:14 |
Separation phenomenon of water, droplet and air | Raymond | CFX | 0 | July 9, 2004 22:59 |
Help!!!problems in air jet into water bath | kim | FLUENT | 4 | June 9, 2003 07:04 |