NACA 4 digit simulation - not converging

dublin · April 23, 2009, 06:11

I'm doing simulations on a NACA 2408 aerofoil, and at angles of attack of about 10degrees or greater it just won't converge, and normally the graph that shows when the solver is running falls into a periodic pattern. I've tried the simulation with various meshes (i.e. more elements in the mesh) and added layers to the inflation boundary around the aerofoil without luck. I've also tried to change from Auto timestep to physical timestep, trying a couple of values there but still no luck. I'm running SST turbulence, and it's a steady state simulation. I'm a complete novice with CFX and any tips on how to get it to converge would be much appreciated, thanks.

ghorrocks · April 23, 2009, 18:36

hi,

Have a look at:

http://www.cfd-online.com/Wiki/Ansys...gence_criteria

I bet it is going transient as you approach the stall point.

Glenn Horrocks

dublin · April 24, 2009, 07:27

Thanks for that. Not really sure what I'm doing now but I'll see if I can get it to run as a transient simulation.

April 23, 2009, 06:11	NACA 4 digit simulation - not converging	#1
dublin New Member Join Date: Apr 2009 Posts: 2 Rep Power: 0	I'm doing simulations on a NACA 2408 aerofoil, and at angles of attack of about 10degrees or greater it just won't converge, and normally the graph that shows when the solver is running falls into a periodic pattern. I've tried the simulation with various meshes (i.e. more elements in the mesh) and added layers to the inflation boundary around the aerofoil without luck. I've also tried to change from Auto timestep to physical timestep, trying a couple of values there but still no luck. I'm running SST turbulence, and it's a steady state simulation. I'm a complete novice with CFX and any tips on how to get it to converge would be much appreciated, thanks.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Transient simulation not converging	skabilan	OpenFOAM Running, Solving & CFD	14	December 16, 2019 23:12
NACA 2412 simulation in CFX - 2nd Run	andrew	CFX	12	December 18, 2013 08:34
2D NACA 0012 simulation in CFX	Hao	CFX	29	March 20, 2009 05:38
NACA 0012 simulation results	Luis	FLUENT	3	February 15, 2006 11:42
NACA 2412 simulation in CFX	andrew	CFX	17	October 26, 2005 01:38

April 23, 2009, 18:36		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,692 Rep Power: 143	hi, Have a look at: http://www.cfd-online.com/Wiki/Ansys...gence_criteria I bet it is going transient as you approach the stall point. Glenn Horrocks

April 24, 2009, 07:27		#3
dublin New Member Join Date: Apr 2009 Posts: 2 Rep Power: 0	Thanks for that. Not really sure what I'm doing now but I'll see if I can get it to run as a transient simulation.