problem!!!!!!!!!! -- CFD Online Discussion Forums

June 9, 2009, 10:00

problem!!!!!!!!!!

mehrdadeng

Member

mohsen

Join Date: Mar 2009

Posts: 53

Rep Power: 18

imported assembly geometry to modeler (attached fig).and enclosure housing.but

model don’t enter to mesh. after a long time meshing tab is empty( attached fig).and no geometry exist in meshing tab.

Is there one to help me????

Attached Images

	modeler error- model4.JPG (51.4 KB, 9 views)
	modeler error-mesh.JPG (55.0 KB, 7 views)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 05:43
Incoherent problem table in hollow-fiber spinning	Gianni	FLUENT	0	April 5, 2008 11:33
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 07:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 20:13
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 15:52

All times are GMT -4. The time now is 15:41.