error message from solver manager

rystokes · June 11, 2009, 02:08

Hi all,

I encountered a error message from solver manager when I ran a transient simulation , it said,
Details of error:-
----------------
Error detected by routine LOCDAT
CDANAM = AROT/VALUE
CRESLT = NONE

Current Directory : /FLOW/PHYSICS/ZN1/MOTION

Writing crash recovery file |

ERROR #001100279 has occurred in subroutine ErrAction. Message:
Stopped in routine MEMERR
An error has occurred in fx5solve:
The ANSYS CFX solver exited with return code 1. No results file has been created.

In this simulation, I firstly made the domain rotating for a period of time, and a res file was generated at the end, as an initial value file for the following simulation, in which the domain suddenly stopped to be stationary.

Has anybody encountered the similar problem please? Any method to fix it? Thanks a lot.

ghorrocks · June 11, 2009, 06:53

Hi,

I suspect that you are doing a rotating frame of reference simulation but have not defined the rotational speed. Make sure it is defined.

Glenn Horrocks

stumpy · June 12, 2009, 06:54

In the restart make the domain stationary by setting a value of zero for the rotation rate, rather than switching to a stationary domain.

June 11, 2009, 02:08	error message from solver manager	#1
rystokes New Member harry Join Date: May 2009 Posts: 29 Rep Power: 16	Hi all, I encountered a error message from solver manager when I ran a transient simulation , it said, Details of error:- ---------------- Error detected by routine LOCDAT CDANAM = AROT/VALUE CRESLT = NONE Current Directory : /FLOW/PHYSICS/ZN1/MOTION Writing crash recovery file \| ERROR #001100279 has occurred in subroutine ErrAction. Message: Stopped in routine MEMERR An error has occurred in fx5solve: The ANSYS CFX solver exited with return code 1. No results file has been created. In this simulation, I firstly made the domain rotating for a period of time, and a res file was generated at the end, as an initial value file for the following simulation, in which the domain suddenly stopped to be stationary. Has anybody encountered the similar problem please? Any method to fix it? Thanks a lot.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Edit/stop run in progress without solver manager	N.R.	CFX	12	June 17, 2015 02:13
Working directory via command line	Luiz	CFX	4	March 6, 2011 20:02
why the solver reject it? Anyone with experience?	bearcat	CFX	6	April 28, 2008 14:08
Solver Manager error message	Ste Lakey	CFX	0	April 26, 2005 05:58
compressible two phase flow in CFX4.4	youngan	CFX	0	July 1, 2003 23:32

June 11, 2009, 06:53		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Hi, I suspect that you are doing a rotating frame of reference simulation but have not defined the rotational speed. Make sure it is defined. Glenn Horrocks

June 12, 2009, 06:54		#3
stumpy Senior Member Join Date: Apr 2009 Posts: 531 Rep Power: 21	In the restart make the domain stationary by setting a value of zero for the rotation rate, rather than switching to a stationary domain.