cfx12 x64 meshing: pc has 4 core but only 1 core working for the mesh? why?

leeruoyun · August 15, 2009, 22:41

cfx12 x64 meshing: pc has 4 core but only 1 core working for the mesh? why?

previously, cfx11, when meshing on 32bit with dual cpu, both 2 cpu working HARD on the mesh....

why 64bit with CFX12 cannot mesh parallel ?

thanks for advices !

yochule · March 17, 2010, 21:18

hello leeruoyun, i'm having the same question....
i'm using cfx12.0 with an amd phenomX4, but when i put cfx meshing i note only one core is used.
can you post your solution if you have?
thanks!

dvolkind · March 23, 2010, 12:37

Hello everybody!

I'm probably too late, but here is a tip if not tried yet. While in cfx-mesh use the outline:
Options->Volume Meshing->Parallel Advancing Front, then set the appropriate number of partitions. Done successfully on 4 different machines, both 32 and 64-bit.

Hope, I've been helpful.

PS That doesn't work with Extruded 2D Mesh.

August 15, 2009, 22:41	cfx12 x64 meshing: pc has 4 core but only 1 core working for the mesh? why?	#1
leeruoyun New Member lee ruoyun Join Date: Aug 2009 Posts: 4 Rep Power: 16	cfx12 x64 meshing: pc has 4 core but only 1 core working for the mesh? why? previously, cfx11, when meshing on 32bit with dual cpu, both 2 cpu working HARD on the mesh.... why 64bit with CFX12 cannot mesh parallel ? thanks for advices !

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit problems	Althea	FLUENT	22	January 4, 2017 03:19
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 05:36
Meshing - Nested mesh block	Mic	FLOW-3D	6	February 17, 2009 09:50
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10
unstructured vs. structured grids	Frank Muldoon	Main CFD Forum	1	January 5, 1999 10:09

March 17, 2010, 21:18		#2
yochule Member nazareno mancinelli Join Date: Mar 2009 Location: argentina Posts: 35 Rep Power: 17	hello leeruoyun, i'm having the same question.... i'm using cfx12.0 with an amd phenomX4, but when i put cfx meshing i note only one core is used. can you post your solution if you have? thanks!

March 23, 2010, 12:37		#3
dvolkind Member Dmitry Volkind Join Date: Jan 2010 Location: Ekaterinburg, Russia Posts: 64 Rep Power: 16	Hello everybody! I'm probably too late, but here is a tip if not tried yet. While in cfx-mesh use the outline: Options->Volume Meshing->Parallel Advancing Front, then set the appropriate number of partitions. Done successfully on 4 different machines, both 32 and 64-bit. Hope, I've been helpful. PS That doesn't work with Extruded 2D Mesh.