2d cfd possible?
hello, is there any way in cfx or workbench to do flow computations on a 2d sketch?
|
hello,
just extrude your 2d mesh into the normal direction for one cell layer ... this can mesh can be used for your "2d" simulation. good luck |
ok, on workbench 12, i've opened desin modeler and the minimum length of the extrude that it gives me is 0.0001[mm], is it ok? thanks...
|
I have always used the length of the extrusion to be equal to the average cell size....
|
|
All times are GMT -4. The time now is 21:35. |