CFD Online Discussion Forums

CFD Online Discussion Forums (
-   CFX (
-   -   Problems with adding two meshes together in CFX Pre (

peterputer1 September 23, 2009 05:25

Problems with adding two meshes together in CFX Pre

i ve a problem when i try to load two meshes in CFX Pre. The first mesh consists of one solid 3d region with some holes. The other mesh contains 7 3d solid parts which fit into these holes. If i load the mesh with the 7 3d regions, my other mesh, that i loaded before, dissapears. The BC are still set for it, but it can not be displayed anymore. Is there anything wrong with the mesh file? To be honest, i already did several meshes, but never had this problem. Usually i just load 2 meshes and everything works fine, but not this time.
Any suggestions?


peterputer1 September 23, 2009 05:36


is it possible that it is not allowed to name a mesh file with a "-" like part1-7? If i rename it, it seems to work...


bharath September 23, 2009 08:08

you may check your units while importing to Pre.different units(mm,m) may cause the problem

All times are GMT -4. The time now is 22:40.