Problems with adding two meshes together in CFX Pre

peterputer1 · September 23, 2009, 05:25

Hej,

i ve a problem when i try to load two meshes in CFX Pre. The first mesh consists of one solid 3d region with some holes. The other mesh contains 7 3d solid parts which fit into these holes. If i load the mesh with the 7 3d regions, my other mesh, that i loaded before, dissapears. The BC are still set for it, but it can not be displayed anymore. Is there anything wrong with the mesh file? To be honest, i already did several meshes, but never had this problem. Usually i just load 2 meshes and everything works fine, but not this time.
Any suggestions?

Regards

peterputer1 · September 23, 2009, 05:36

Hej,

is it possible that it is not allowed to name a mesh file with a "-" like part1-7? If i rename it, it seems to work...

Regards

bharath · September 23, 2009, 08:08

you may check your units while importing to Pre.different units(mm,m) may cause the problem

September 23, 2009, 05:25	Problems with adding two meshes together in CFX Pre	#1
peterputer1 New Member Join Date: Sep 2009 Posts: 9 Rep Power: 16	Hej, i ve a problem when i try to load two meshes in CFX Pre. The first mesh consists of one solid 3d region with some holes. The other mesh contains 7 3d solid parts which fit into these holes. If i load the mesh with the 7 3d regions, my other mesh, that i loaded before, dissapears. The BC are still set for it, but it can not be displayed anymore. Is there anything wrong with the mesh file? To be honest, i already did several meshes, but never had this problem. Usually i just load 2 meshes and everything works fine, but not this time. Any suggestions? Regards

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFX Pre Hide symmetry symbols	alvid	CFX	2	August 15, 2007 11:34
CFX 5.7.1 PRE and solver won't start	daniel	CFX	1	January 20, 2006 10:09
Problems installing CFX on Sun Unix Platform	Haley	CFX	2	November 9, 2001 09:52
unstructured grid	sreekanth	Main CFD Forum	1	August 6, 2001 15:09
CFX problems no NT?	Michael Bo Hansen	CFX	0	September 28, 2000 09:55

September 23, 2009, 05:36		#2
peterputer1 New Member Join Date: Sep 2009 Posts: 9 Rep Power: 16	Hej, is it possible that it is not allowed to name a mesh file with a "-" like part1-7? If i rename it, it seems to work... Regards

September 23, 2009, 08:08		#3
bharath Senior Member Bharath kumar Join Date: Apr 2009 Posts: 169 Rep Power: 17	you may check your units while importing to Pre.different units(mm,m) may cause the problem