|
[Sponsors] |
October 30, 2009, 13:47 |
Turbulence Model
|
#1 |
New Member
sam13
Join Date: Jul 2009
Location: St. John's, NL, Canada
Posts: 23
Rep Power: 16 |
Hi all,
Is there any turbulence model available in CFX 11.0 other than k-epsilon & SST model? I found only these two types; k-epsilon & SST model. I need other turbulence models too, specially one equation model for my research work. Please help me. Thanks, Shafiul |
|
October 30, 2009, 14:21 |
|
#2 |
New Member
Michael Page
Join Date: Oct 2009
Posts: 4
Rep Power: 16 |
Hi Shafiul,
Normally, there is a little square with three dots at the right of the menu to choose your turbulence model. Click on it and you will see all turbulence model compatible with your case. Regards,
__________________
Michael Page, ing. Engineer in calculation and simulation IDEA innovation PME (418) 695-4332 |
|
October 31, 2009, 04:28 |
|
#3 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,692
Rep Power: 143 |
Also note that the basic CFX license does not give you access the full range of available turbulence models. You should check the license you have.
|
|
October 31, 2009, 13:14 |
|
#4 |
New Member
sam13
Join Date: Jul 2009
Location: St. John's, NL, Canada
Posts: 23
Rep Power: 16 |
Thank you very much Michael and ghorrocks for your valuable suggestions.
You guys saved me from my angry supervisor. lol Thank you again. Shafiul |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Eul-Eul flow, k-e-kp-ep-Theta Turbulence model | us | FLUENT | 5 | April 5, 2011 02:29 |
KOmega Turbulence model from wwwopenFOAMWikinet | philippose | OpenFOAM Running, Solving & CFD | 30 | August 4, 2010 10:26 |
Fan heater model: what turbulence source to use? | andy20 | CFX | 7 | March 3, 2008 16:42 |
validating turbulence model on flow around a car | Pedro | CFX | 1 | February 20, 2008 16:32 |
SSG Reynolds Turbulence Model | Georges | CFX | 1 | February 28, 2007 16:15 |