Motion solid

Clif · May 19, 2010, 07:05

Read the CFX and the following questions arose on the motion of solid domain:
how to set the velocity components (U, V, W), to solid domain (gray rectangle) to move only along the Z axis at a speed of 0.1 m / s?
how to need to have solid domain to the brink of A and B are identical?

calculation should be done in transient regime during the complete passage of the necessary path?

how to set up a final border will move solid ?

Explain how to configure whether good motion solid. questions probably elementary, but it is difficult to understand without help.

http://xmages.net/thumb/thumb_f64a3ea1.jpg

ghorrocks · May 19, 2010, 18:32

Why don't you model this as a domain with a translating bottom wall? No need for immersed solids then.

May 19, 2010, 07:05	Motion solid	#1
Clif New Member Join Date: Aug 2009 Posts: 10 Rep Power: 16	Read the CFX and the following questions arose on the motion of solid domain: how to set the velocity components (U, V, W), to solid domain (gray rectangle) to move only along the Z axis at a speed of 0.1 m / s? how to need to have solid domain to the brink of A and B are identical? calculation should be done in transient regime during the complete passage of the necessary path? how to set up a final border will move solid ? Explain how to configure whether good motion solid. questions probably elementary, but it is difficult to understand without help. http://xmages.net/thumb/thumb_f64a3ea1.jpg

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Snappyhexmesh and solid body motion	erik023	OpenFOAM Running, Solving & CFD	1	October 24, 2008 04:53
Multiple Solid Domains - Interfaces	Scott	CFX	8	July 31, 2008 15:20
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 14:09
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

May 19, 2010, 18:32		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Why don't you model this as a domain with a translating bottom wall? No need for immersed solids then.