Error #001100279

c120613 · December 4, 2009, 16:36

Dear all I'm working on ANSYS CFX in order to solve the flow around a low pressure turbine. I'm a beginner of ANSYS CFX I don't understand the error that I have had after the running CFX some the ERROR #001100279, but I don't understand the reason.

Can somebody to explain to me what is happened?

Thanks in advance

Domenico

ghorrocks · December 5, 2009, 05:03

Your simulation has diverged. Try starting with a smaller timestep or possibly a local timescale factor. Once it has started converging then you can wind the timestep up (or return to physical timescale if you used local timescale).

bharath · December 8, 2009, 21:07

Hi c120613,
I think you made mistake with material settings or mesh units setting.Note that the inlet velocity 8.2678E+03 m/s.So the mach no is more and it results in Solver failure.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

December 5, 2009, 05:03		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,697 Rep Power: 143	Your simulation has diverged. Try starting with a smaller timestep or possibly a local timescale factor. Once it has started converging then you can wind the timestep up (or return to physical timescale if you used local timescale).

December 8, 2009, 21:07		#3
bharath Senior Member Bharath kumar Join Date: Apr 2009 Posts: 169 Rep Power: 17	Hi c120613, I think you made mistake with material settings or mesh units setting.Note that the inlet velocity 8.2678E+03 m/s.So the mach no is more and it results in Solver failure.