|
[Sponsors] |
December 5, 2009, 21:37 |
cfx 11 PEEKCA error
|
#1 |
New Member
Join Date: Jul 2009
Posts: 25
Rep Power: 16 |
hi,
I am running a conjugate simulation with CFX and there are a lot of interfaces between solid and fluid. The simulations run ok, but when i stop the simulation, it always prints out following error before final ending of simulation. The res file was generated and I can process in CFX-post. Everything looks fine except the error message which bothers me. How can I solve this error? Can I trust results (which looks reasonable) with such an error? Thanks a lot. Details of error:- ---------------- Error detected by routine PEEKCA CDANAM = CVAR CRESLT = NONE Current Directory : /FLOW/SOLUTION/TSTEP68/CLOOP1/ZN4/BELG28/IP +--------------------------------------------------------------------+ | ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | Stopped in routine MEMERR | +--------------------------------------------------------------------+ End of solution stage. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
UDF: DEFINE_CG_MOTION for vertical jump motion of an electrode! | alban | Fluent UDF and Scheme Programming | 2 | June 8, 2010 18:54 |
[Netgen] Installation of Netgen in SuSE Linux 92 | edvardsenpriv | OpenFOAM Meshing & Mesh Conversion | 23 | January 16, 2009 06:12 |
How to get the max value of the whole field | waynezw0618 | OpenFOAM Running, Solving & CFD | 4 | June 17, 2008 05:07 |
Installation problem with GCC | Norma McKee (Mckee) | OpenFOAM Installation | 10 | March 4, 2007 07:09 |