Imbalance in transient simulation

Roland R · December 8, 2009, 09:50

Hi,

While the calculation is running, I always check the mass/energy imbalance and the mass flow at the inlet/outlet.

In steady state simulation there is not problem with these, but I don't understand what does the mass imbalance mean in the case of transient simulation. End of every timestep the imbalance is under 0.1% but the mass flow at inlet and outlet are different (for example 0.3kg/s @inflow and 0.35 kg/s @outflow).
How is this possible?

Regards
Roland.R

Attesz · December 8, 2009, 11:05

Hát ez tényleg elég érdekes, kíváncsi vagyok

ghorrocks · December 8, 2009, 16:55

Assuming your imbalances are small, in a transient simulation it means your modelled domain is loosing mass. This can only happen in a compressible simulation. If it is happening in a incompressible simulation then you have a problem.

Roland R · December 9, 2009, 05:39

I thought so

Thank you;

Roland R.

December 8, 2009, 09:50	Imbalance in transient simulation	#1
Roland R Senior Member Roland Rakos Join Date: Mar 2009 Posts: 131 Rep Power: 17	Hi, While the calculation is running, I always check the mass/energy imbalance and the mass flow at the inlet/outlet. In steady state simulation there is not problem with these, but I don't understand what does the mass imbalance mean in the case of transient simulation. End of every timestep the imbalance is under 0.1% but the mass flow at inlet and outlet are different (for example 0.3kg/s @inflow and 0.35 kg/s @outflow). How is this possible? Regards Roland.R

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Steady-state simulation to start a transient simulation	smagmon	CFX	2	May 18, 2009 03:59
Transient simulation - pressure shifted	Eric	CFX	1	February 14, 2006 12:42
Timestep for transient simulation	houman	CFX	2	April 28, 2005 03:44
Charts for transient simulation	Anurag	CFX	2	March 28, 2005 12:09
Transient Simulation for pipe flow	Sam	CFX	0	January 7, 2005 00:06

December 8, 2009, 11:05		#2
Attesz Senior Member Attesz Join Date: Mar 2009 Location: Munich Posts: 368 Rep Power: 17	Hát ez tényleg elég érdekes, kíváncsi vagyok

December 8, 2009, 16:55		#3
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,700 Rep Power: 143	Assuming your imbalances are small, in a transient simulation it means your modelled domain is loosing mass. This can only happen in a compressible simulation. If it is happening in a incompressible simulation then you have a problem.

December 9, 2009, 05:39		#4
Roland R Senior Member Roland Rakos Join Date: Mar 2009 Posts: 131 Rep Power: 17	I thought so Thank you; Roland R.