|January 20, 2010, 20:31||
mohamed shawky ismail
Join Date: Jan 2010
Posts: 5Rep Power: 9
hi every body
i try to solve simple problem flow inside tube but it have thickness 2mm so i draw two parts with two body and convert them to one part(assembly) as tutrial conjecated heat transfer. but in this tutorial after solving the heat flux at any point in (Domain Interface 1 Side 1 OR Domain Interface 1 Side 2) is exactly the same .
but,in my problem not the same and by mind this two interfaces is one surface so the heat flux must be the same
what is the error?!!!!!!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||45||February 8, 2016 05:42|
|GGI (General Grid Interface) Connections||feixiangniao||CFX||4||January 14, 2010 20:51|
|interface boundary problem||Rashad||FLUENT||0||April 23, 2007 05:27|
|Interface problem||sai||FLUENT||1||January 19, 2007 03:26|
|Replace periodic by inlet-outlet pair||lego||CFX||3||November 5, 2002 21:09|