 |
 |
 |
|
|
|
[Sponsors] | ||||
February 3, 2010, 09:29
|
Geometry modification
|
#1 |
|
New Member
Join Date: Jun 2009
Posts: 9
Rep Power: 16  |
I am new to CFX. I've a geometry that was given to run simulation but I'll like to make some modifications to the inlet which is just adding like face or wall to it to reduce the inlet.
How can I access the geometry with already mesh in place? |
|
|
|
|
|
February 3, 2010, 22:33
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
You will need to load it into a mesh editor such as ICEM. In general this is a bad idea and you will want to remodel the geometry and remesh.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rotor 67 full compressor geometry | jf | Main CFD Forum | 3 | January 28, 2024 05:14 |
| [ICEM] O-grid around wing geometry | Anorky | ANSYS Meshing & Geometry | 15 | November 27, 2017 13:43 |
| Importing CAD geometry and Editing edges to match | Ahmed | CFX | 15 | March 21, 2016 12:39 |
| Simulation of Flow through Complex 3D Geometry | EmersonKB | CFX | 5 | July 2, 2009 08:17 |
| vitual _ real | deneb | FLUENT | 3 | January 22, 2007 04:31 |
Linear Mode
