joining two domains using boundary conditions

mealyj · February 2, 2010, 07:54

hi all,

is it possible to connect the outflow from one domain to the inflow of another domain in ansys? i have specified different fluids in each domain and i want one to flow into the other and mix. any ideas?

cheers.

ghorrocks · February 2, 2010, 16:28

You might be able to connect them using periodic boundary conditions.

gaoguohua · February 4, 2010, 02:12

I think you just need the Domain Interface instead of any boundary condition.

ghorrocks · February 4, 2010, 05:00

Good point - it depends on what you are trying to do. Can you describe what you are trying to do with this inlet/outlet more? Can you post a picture?

Attesz · February 4, 2010, 11:09

Quote:

Originally Posted by gaoguohua

I think you just need the Domain Interface instead of any boundary condition.

I think, if you are using interface for domains, you can use only one fluid type, or am I wrong?

mealyj · February 10, 2010, 10:31

Yeah, I was actually just making the problem more complicated than it needed to be. But a domain interface definitely works best I think.

Thanks for your help guys.

February 2, 2010, 07:54	joining two domains using boundary conditions	#1
mealyj New Member Jake Mealy Join Date: Jan 2010 Posts: 6 Rep Power: 16	hi all, is it possible to connect the outflow from one domain to the inflow of another domain in ansys? i have specified different fluids in each domain and i want one to flow into the other and mix. any ideas? cheers.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Impinging Jet Boundary Conditions	Anindya	Main CFD Forum	25	February 27, 2016 12:58
Problems with boundary conditions for a lowRekOmegaSST turbulence model	cfdmarkus	OpenFOAM Running, Solving & CFD	16	November 14, 2011 04:44
Concentric tube heat exchanger (Air-Water)	Young	CFX	5	October 6, 2008 23:17
Pressure boundary conditions	Lionel S.	Main CFD Forum	1	August 24, 2007 18:03
A problem about setting boundary conditions	lyang	Main CFD Forum	0	September 19, 1999 18:29

February 2, 2010, 16:28		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	You might be able to connect them using periodic boundary conditions.

February 4, 2010, 02:12		#3
gaoguohua New Member Guohua Gao Join Date: Feb 2010 Posts: 3 Rep Power: 16	I think you just need the Domain Interface instead of any boundary condition.

February 4, 2010, 05:00		#4
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Good point - it depends on what you are trying to do. Can you describe what you are trying to do with this inlet/outlet more? Can you post a picture?

February 10, 2010, 10:31		#6
mealyj New Member Jake Mealy Join Date: Jan 2010 Posts: 6 Rep Power: 16	Yeah, I was actually just making the problem more complicated than it needed to be. But a domain interface definitely works best I think. Thanks for your help guys.